|
TruBond
No-Mix adhesive system is the bonding system with many years of
track record. During more than five years of sales of this adhesive
system we are yet to receive even a single complaint. We offer only
the best adhesive system for we understand that a good adhesive
system brings a lot of relief and security to a clinician from debonding
problems.
Can be used for all types of metal, ceramic or composite brackets.
Shelf life is 30 months, which can be further, increased upto 4
years by refrigerating the kit when not in use.
Material should not be stored in proximity of eugenol containing
products.
Do not expose materials to very high temperatures like those found
in a parked car in sun, when you go for visiting practice.
Be certain to avoid cross contamination of the paste and primer.
The presence of either material in the other will result in hardening
the material.
Never use a disposable brush or spatula a second time. Never dip
a brush into primer, which has come in contact with the adhesive
paste. It would be a source of contamination.
Instruct your assistant to keep the primer bottle close after dispensing
the required amount. It would help in avoiding the thickening of
primer, which can affect bonding strength due to poor penetration
of primer in enamel tags.
Tooth Preparation:
Clean: Thoroughly clean teeth to be bonded with
plain pumice. Prophy paste, which contains oil or fluoride, should
not be used. They can leave a residue which may inhibit the etch.
Rinse teeth completely with a large amount of water. Dry with oil/moisture
free compressed air.
Etch: Apply etchant on the entire area to be bonded
using a mini sponge or brush. Do not rub the etchant on to the enamel.
Etching should be complete in 30 seconds. Allow 120 seconds for
deciduous teeth. Make sure to avoid placing etchant on soft tissue.
Rinse and Dry: Rinse thoroughly with water to remove
all traces of etchant. Do not allow the patient to rinse or contaminate
the etched surface. Re- isolate and dry completely using oil/moisture
free compressed air. The conditioned area should appear dull and
frosty white. If not, re-etch for an additional 20 seconds.
Bonding Procedure:
Apply a thin coat of primer to each etched, dry tooth on the surface
to which bracket is to be bonded and the underside of each bracket
base. A small quantity of paste is applied to the bracket base.
Place on tooth and within 20 seconds move the bracket to the desired
position and press firmly. Excess adhesive can be moved easily from
the periphery of the bracket base after bracket is in place. After
5 minutes, an archwire can be inserted.
Bracket Removal
To remove a bracket use a debonding plier or a ligature cutter and
grab the adhesive at the enamel / adhesive interface and separate
from the tooth surface. Any remaining adhesive can be removed with
slow speed carbide burs or a scaler.
Available as
Three
syringe kit containing 3 syringes of adhesive paste 5 gm
each, 16 cc Primer in glass bottle, 9 gm etchant and accessories
Single syringe kit containing one 5 gm syringe
of adhesive paste, 7cc primer in dropper bottle and 9 gm etchant
Adhesive paste, Primer and Etchant are also available separately.
|
